Features

The Flush-mount cable tie

The tamper-proof, Push-Mount Wire Tie features a low profile to prevent snagging when the cable is trimmed and the harness is pulled through a bulkhead. The remaining terminal end falls below the low-profile receptacle, eliminating sharp edges common in most wire ties. The device snaps quickly into a panel sheet with a maximum thickness of .135”.
 

Device Technologies
www.rsleads.com/610cn-341

Cable service kit

The CableIQ Service Kit includes the CableIQ Qualification Tester, the IntelliTone Probe and the LinkRunner Network Multimeter. The kit assists with cabling troubleshooting and network service verification. Both passive connectivity and active communications tests can be performed on network operation. The cable kit reduces the amount of staff time required to perform these tasks, provides detailed information on the nature and location of cabling faults, shows distance to open and shorts, and identifies what is at the far end of any cable.

Fluke Networks
www.rsleads.com/610cn-308

Crimp connectors

The BNC RFB-1106-I and TNC RFT-1202-I are designed to perform to a minimum of 4 Ghz or 7 Ghz, depending on the coaxial cable used in the assembly. Both connectors feature gold-plated contacts, which can be soldered or crimped, and are Teflon insulated with nickel-plated brass bodies.

RF Industries
www.rsleads.com/610cn-309

Remote-access controller

The Master Calibration Cable is tested for optical and mechanical performance against rigid tolerances, with supporting documentation for insertion loss, return loss and interferometric measurements prior to receiving “master calibration” status. Timbercon offers a recertification service for each cable, allowing the user to return the cable at determined intervals for inspection, cleaning and, if necessary, re-polishing and/or re-termination. Upon completion, each cable receives an updated performance/test report and a re-certified status. The cables utilize red-jacketed fiber for easy differentiation from standard fiber cables and serialization to allow matching to accompanying performance/test documentation. All cables are available in single mode or multimode, simplex or duplex, with a wide range of connector, length, jacketing and custom options to suit any environment.

Timbercon
www.rsleads.com/610cn-311

Power strips

PowerOptions features A and B power feed options, IEC plug choices, surge protection and current monitoring, and are suited for cabinetized data server applications. The power strips are available in rackmount and vertical designs. Rackmount sizes fit 19”- and 23”-wide cabinets, and vertical up to 66 inches. Strips come with a versatile bracket, a variety of receptacle styles and cord lengths, as well as circuit breakers. Users can swivel power strips 180 degrees. The range accommodates three-phase, 250-volt and 30-amp power. Customers can request either IEC or NEMA connectors with any strip.

APWMayville
www.rsleads.com/610cn-316

Ribbon outdoor cables

SST-UltraRibbon Gel-Free cable is a high-fiber-count outdoor ribbon cable, in which dry water-blocking materials have completely replaced the gels. The cable is available in fiber counts of 288, 360 and 432. Benefits include reduced cable preparation time, quicker network deployment,
removal of gel-cleaning solvents from the workplace, reduced mass-fusion splicer maintenance and elimination of the need for cable-damming procedures. The cables are fully compliant to the ICEA outside plant cable standard and Telcordia GR-20-CORE Issue 2 requirements. It is able to fit in 1.25-inch inner diameter or larger inner ducts. Dielectric and armored jacket options are available.

Corning Cable Systems
www.rsleads.com/610cn-310